Fujitsu YOKOGAWA AF221 Application Note - Page 19

Browse online or download pdf Application Note for Motherboard Fujitsu YOKOGAWA AF221. Fujitsu YOKOGAWA AF221 24 pages. Flash programmer - f2mc-16lx family 16-bit microcontroller all series

Print Page

9 External Key Entry Interface AZ233

This chapter describes how to use two external buttons to control the Flash-Programmer
In order to integrate the Yokogawa Flash-Programmer in an automatic assembly line, two
external switch-buttons or relays connected to EXT.KEX can be used to start a command
sequencer.
A command sequence file (*.CSB) is used to define the function.
In case that the signal lines OAK1+ and OAK1- respectively OAK2+ and OAK2- are shortcut
the command sequence LK1 respectively LK2, stored in the CSB-file, is started.
Alternatively two buttons of the keypad can be used, see
This text file consists of two lines. It can be easily edited, e.g.:
my.csb:
LK1,04,E,B,P,R;remark: Erase/BlankCheck/Program/Verify [
LK2,01,P;remark: only Program without erasing the chip [
Number of commands
Note: A maximum number of 16 commands can be executed within one sequence.
© Fujitsu Microelectronics Europe GmbH
FLASH PROGRAMMER YOKOGAWA AF220/221
External Key Entry Interface AZ233
Command Sequence
E
ERASE
B
Blank Check
Figure 6-20: One Action key
- 19 -
P
Program
R
Read Check (Verify)
EXT.KEY
CRLF]
CRLF]
MCU-AN-390087-E-V10