Indesit HOTPOINT HVL211UK Service Information - Page 19

Browse online or download pdf Service Information for Washer Indesit HOTPOINT HVL211UK. Indesit HOTPOINT HVL211UK 23 pages.

Print Page

Safety Notes:

Ensure that the appliance is disconnected from the Electricity Supply before

commencing any work.

Beware of sharp edges on metal or plastic parts - wear safety gloves.

Refer to the Safety Notes at the beginning of this publication.

A. Top Cover

1. Remove the 2 screws securing the top panel.

2. Lift clear.

B. Back Panel

1. Remove the 6 screws securing the panel.

2. Lift the panel clear.

C. Control Panel

1. Remove the top cover (A).

2. Open the dispenser drawer fully, gently lift slightly on the right hand side, grip draw front and pull

to remove dispenser.

3. Remove the dispenser front hinge pin and lift clear.

4. Remove the wash programme selector knob and variable temperature knob by pulling away from

the control panel.

5. Release the two screws, one each end on top corner of the control panel and two screws on upper

edge of dispenser drawer area.

6. Release the 2 clips holding the control panel to the cabinet, gently ease the control panel upwards

to disengage the lugs from the front panel.

7. Disconnect the wiring and lift clear.

Note: - When refitting, ensure the control panel is screwed and secured into the dispenser body.

This is easier to check with the dispenser draw removed.

D. Control Card & Selectors

1. Remove the top cover (A).

2. Release the wiring block from the back of the card.

3. Remove 4 crosshead screws fixing the PCB to the control panel and lift away.

4. Remove the programme and variable temperature knobs using switch removal tool (Part Number

5600126), disconnect the wiring and lift clear.

E. Top Counterweight

1. Remove the top cover (A).

2. Remove the tank / drum assembly (O).

3. Remove the 4 screws securing the cabinet support bar.

4. Remove 3 x 10 mm bolts securing the weight to the outer drum and lift clear.

DISMANTLING INSTRUCTIONS