Indesit I5G52G /UA Operating Instructions Manual - Page 16

Browse online or download pdf Operating Instructions Manual for Cookers Indesit I5G52G /UA. Indesit I5G52G /UA 32 pages. Cooker and oven

Print Page

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity supply

before carrying out any work on it.

Cleaning the appliance

! Do not use abrasive or corrosive detergents such as

stain removers, anti-rust products, powder detergents

or sponges with abrasive surfaces: these may scratch

the surface beyond repair.

! Never use steam cleaners or pressure cleaners on

the appliance.

• It is usually sufficient simply to wash the hob using a

damp sponge and dry it with absorbent kitchen roll.

• The stainless steel or enamel-coated external parts

and the rubber seals may be cleaned using a

sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for the

removal of stubborn stains. After cleaning, rinse well

and dry thoroughly. Do not use abrasive powders or

corrosive substances.

• The hob grids, burner caps, flame spreader rings

and the hob burners can be removed

to make cleaning easier; wash them in hot water and

non-abrasive detergent, making sure all burnt-on

residue is removed before drying them thoroughly.

• For hobs with electronic ignition, the terminal part of

the electronic lighting devices should be cleaned

frequently and the gas outlet holes should be

checked for blockages.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with a

soft cloth. Do not use abrasive products.

•

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these

could scratch the surface and cause the glass to

crack.

• The accessories can be washed like everyday

crockery, and are even dishwasher safe.

• Stainless steel can be marked by hard water that

has been left on the surface for a long time, or by

aggressive detergents containing phosphorus.

After cleaning, rinse well and dry thoroughly. Any

remaining drops of water should also be dried.

The cover

! Do not close the cover when the burners are alight or

when they are still hot.

Inspecting the oven seals

Check the door seals around the oven periodically. If

the seals are damaged, please contact your nearest

Authorised After-sales Service Centre. We recommend

that the oven is not used until the seals have been

replaced.

Gas tap maintenance

Over time, the taps may become jammed or difficult to

turn. If this occurs, the tap must be replaced.

! This procedure must be performed by a qualified

technician who has been authorised by the

manufacturer.

Replacing the oven light bulb

1. After disconnecting the

oven from the electricity mains,

remove the glass lid covering

the lamp socket (see fi gure).

2. Remove the light bulb and

replace it with a similar one:

voltage 230 V, wattage 25 W,

cap E 14.

3. Replace the lid and reconnect the oven to the

electricity supply.

! Do not use the oven lamp as/for ambient lighting.

Assistance

Please have the following information handy:

• The appliance model (Mod.).

• The serial number (S/N).

This information can be found on the data plate located

on the appliance and/or on the packaging.

If the cooker is fitted with

a glass cover, this cover

should be cleaned using

lukewarm water. Do not

use abrasive products.

It is possible to remove

the cover in order to make

cleaning the area behind

the hob easier. Open

the cover fully and pull it

upwards (see fi gure).