A-Neuvideo ANI-5MFS Instruction Manual - Page 7

Browse online or download pdf Instruction Manual for Switch A-Neuvideo ANI-5MFS. A-Neuvideo ANI-5MFS 20 pages. 5x1 4k2k@60hz presentation switcher w/ hdmi & hdbaset output

Print Page

NEUVIDEO

BACK PANEL

CONTROL PORTS:

• LAN:

This port is the link for Web GUI control; connect to an active Ethernet link with an RJ-45 terminated cable.

• RS-232:

Serial control port, 3P captive screw connector, connects with a control device (such as a computer) to control the

switcher or other device connected with the HDBaseT

• IR IN:

Connects with IR receiver cable (with carrier wave), to receive IR signals sent by the IR remote or remote controller of

other input/output device.

• IR OUT:

Connects with IR emitter cable used for controlling the local source device or the switcher.

• CONTACT IN:

This input control reserving for direct source input selection. Connect ground pin (mark as on panel) with following

pin number for individual source selection.

PIN NUMBER

SOURCE

Pin 1

HDMI1

Pin 2

HDMI2

Pin 3

HDMI3

Pin 4

Display Port

Pin 5

VGA/YPbPr/CVBS

AUDIO PORTS:

• OUT:

The audio comes from the input audio corresponding to the selected video source and mixed with MIC audio. Connects

with amplifier for audio source broadcasting.

• HDMI1/2/3/DP:

Select the external analog audio on OSD and insert the audio to HDMI1/2/3/DP video source then output to

display and analog audio output port.

• VGA:

The external analog audio input for VGA input.

• MIC IN:

Plug microphone in for audio source output.

• PHANTOM ON/OFF:

professional 48V phantom microphone.

OUTPUT PORTS

• HDBASET

OUT:

™

• HDMI OUT:

Connect to an HDMI display or AV Receiver for video and/or audio output.

INPUT PORTS:

These video input ports include (3) HDMI inputs, (1) Display Port input & (1) VGA input. VGA port support VGA, YPbPr

and CVBS format. Factory default is VGA format.

USB PORT:

USB port connects with USB flash disk or other storage that contains the software update file to update the system

firmware.

POWER:

Plug the 24V DC power supply into the unit and connect the adaptor to an AC outlet.

Arrange the slide switch to "OFF" for electrets condenser microphone/ dynamic microphones or "ON" for

Connects with compatible Receiver for video and / or audio output. Support 24V POC function.

receiver.

™

BACK PANEL