AEG ARCTIS G 9 88 50-4i Operating And Installation Instruction - Page 14
Browse online or download pdf Operating And Installation Instruction for Freezer AEG ARCTIS G 9 88 50-4i. AEG ARCTIS G 9 88 50-4i 20 pages. Integrated freezer
Also for AEG ARCTIS G 9 88 50-4i: Operating And Installation Instructions (21 pages)
Print Page
Symptom
Appliance does not work no
pilot light is illuminated.
Green light does not light up,
yellow light lights up when
frostmatic fuction is activa-
ted, appliance is on.
Yellow light does not light up,
when frostmatic fuction is
activated, appliance is on.
Appliance cools too much.
The freezer temperature is not
sufficient, red light lights up,
temperature alarm sounds
Heavy build up of frost, possi-
bly also on the door seal.
The compressor does not start
immediately after changing
the temperature setting.
If, after carrying out the necessary checks there is still a fault with your
appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested checks have
been made as the engineer will make a charge if the fault is not a mecha-
nical or electrical breakdown.
Please note that proof of purchase is required for any in-guarantee service
calls.
14
Possible Cause
Appliance is not switched on Switch on the appliance.
Mains plug is not plugged in
or is loose.
Fuse has blown or is defective.
Socket is defective.
Green light faulty.
Yellow light faulty.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
A large quantity of warm
food was placed in the
appliance within the last 24
hours.
The appliance is near a heat
source.
Door seal is not air tight (pos-
sibly after changing over the
hinges).
This is normal, no error has
occurred.
Remedy
Insert mains plug.
Check fuse, replace if neces-
sary.
Mains malfunctions are to be
corrected by an electrician.
Please inform your local AEG
Service Force Centre
Please inform your local AEG
Service Force Centre
Press the temperature setting
button to a warmer setting.
Please look in the "Initial Start
Up" section.
Open the door only as long as
necessary.
Press the frostmatic switch
Please look in the "Installation
location" section.
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand until it sits cor-
rectly.
The compressor starts after a
period of time.