AEG ARCTIS No-frost (frost free) Operating Instructions Manual - Page 23

Browse online or download pdf Operating Instructions Manual for Freezer AEG ARCTIS No-frost (frost free). AEG ARCTIS No-frost (frost free) 40 pages. No-frost (frost free) cooling and freezing appliance

Print Page

2. Set the temperature depending upon the selected operation mode (see

the chapter "Setting the Temperature").

Attention! If you are using the appliance as a freezing unit: Please wait

prior to putting the foodstuff to be frozen, until the freezer interior

temperature has attained -18 °C, or until the red warning display goes

off.

Attention! If you are using this appliance as a cooling unit, after it has

been used as a freezing unit: Please wait until the temperature has

reached 0 °C before putting the foodstuff to be cooled in the appliance.

Temperature Adjustment

1. Press either the „+" (WARMER) or „-" (COLDER) button.

The temperature display switches over and the DESIRED temperature

currently set flashes on the temperature display.

2. To adjust to a warmer temperature, press the „+" (WARMER) button. To

adjust to a colder temperature, press the „-" (COLDER) button. The

changed setting is immediately displayed on the temperature display.

Each time one of the two buttons is pressed again the DESIRED temper-

ature is adjusted by 1 °C.

Note: From a food safety point of view, -18 °C should be considered

cold enough as a storage temperature.

When the buttons are not further pressed after an adjustment has been

made, after a short period (approx. 5 sec.) the temperature display swit-

ches over and again displays the ACTUAL temperature in the freezer

compartment. The display changes from flashing to continuous illumi-

nation.

The following DESIRED temperature settings are possible:

• Operating mode "Freezing": from -15 °C up to -24 °C in 1 °C steps;

• Operation mode "Cooling": from 0 °C up to 16 °C in 1 °C steps;

Attention! If the operation mode "Cooling" is selected, the ambient

temperature at the installation place must be at least 2 °C higher than

the preset DESIRED temperature.

Important! Please regularly check that the storage temperature is

being maintained by checking the red warning light and the tempera-

ture display.