AEG S51800DSW0 User Manual - Page 13

Browse online or download pdf User Manual for Freezer AEG S51800DSW0. AEG S51800DSW0 44 pages.

Print Page

Problem

Water flows on the

ground.

The temperature in the

appliance is too low.

The temperature in the

appliance is too high.

The temperature in the re-

frigerator is too high.

The temperature in the

freezer is too high.

There is too much frost.

Replacing the lamp

1. Disconnect the appliance.

2. Push the movable part to unhook the

lamp cover (1).

3. Remove the lamp cover (2).

4. Replace the lamp with one of the same

power and specifically designed for do-

mestic appliances only.

5. Install the lamp cover.

6. Connect the appliance.

7. Open the door. Make sure that the lamp comes on.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "Installation".

3. If necessary, replace the defective door gaskets. Contact the Service Center.

Possible cause

The melting water outlet does

not flow in the evaporative tray

above the compressor.

The temperature regulator is not

set correctly.

The temperature regulator is not

set correctly.

The door is not closed correctly.

The product temperature is too

high.

Many products are stored at the

same time.

There is no cold air circulation in

the appliance.

Products are too near to each

other.

Food is not wrapped correctly.

The door is not closed correctly.

The temperature regulator is not

set correctly.

What to do if...

Solution

Attach the melting water outlet

to the evaporative tray.

Set a higher temperature.

Set a lower temperature.

Refer to "Closing the door".

Let the product temperature de-

crease to room temperature be-

fore storage.

Store less products at the same

time.

Make sure that there is cold air

circulation in the appliance.

Store products so that there is

cold air circulation.

Wrap the food correctly.

Refer to "Closing the door".

Set a higher temperature.