AEG SANTO C 7 18 40-4I Operating And Installation Instruction - Page 27

Print Page

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light bulb,

switch off the appliance and unplug it, or pull the fuse or the circuit breaker.

Light bulb data: replace the lamp with one of the same power (the maximum

power is shown on the light diffuser).

To switch off the appliance, press the

temperature button to position

"0FF".

Unplug the mains plug.

To change the light bulb press on the

rear hook and at the same time slide

the cover in the direction indicated

by the arrow.

Change the defective light bulb.

Refit the light bulb cover.

Put the refrigerator back into opera-

tion.

This appliance was designed for household use and was manufactured in

accordance with the appropriate standards. The necessary measures in

accordance with appliance safety legislation regulations (GSG), accident

prevention regulations for refrigeration appliances (VBG 20) and the regu-

lations of the German Society of Electrical Engineers (VDE) were observed in

the manufacture of this appliance.

The refrigerant circuit has been checked for leaks.

This appliance is in accordance with the following EU guidelines:

– 73/23/EWG dated 19 February 1973 - low voltage guidelines.

– 89/336/EWG dated 3 May 1989

(including guideline change notice 92/31/EWG) - EMV guideline