AEG SCB6182VNS User Manual - Page 13
Browse online or download pdf User Manual for Freezer AEG SCB6182VNS. AEG SCB6182VNS 20 pages.
Print Page
Problem
The compressor does not
start immediately after
pressing the "Frostmatic",
or after changing the tem-
perature.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Appliance is fully loaded
and it is set to the lowest
temperature
Temperature set in the ap-
pliance is too low and the
ambient temperature is
too high.
This is normal, no error has
occurred.
Food products prevent the
water to flow into the wa-
ter collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The "Frostmatic function"
is switched on.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "Frostmatic function"
is switched on.
There is no cold air circula-
tion in the appliance.
ENGLISH
Solution
Set a higher temperature. Re-
fer to "Operation".
Set a higher temperature. Re-
fer to "Operation"
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.
Switch off "Frostmatic func-
tion" manually, or wait until
the function resets automati-
cally to set the temperature.
Refer to "Frostmatic function".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Add less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "Frostmatic function".
Make sure that there is cold air
circulation in the appliance.
13