AEG 8359 D Installation And Operating Instructions Manual - Page 10

Browse online or download pdf Installation And Operating Instructions Manual for Ventilation Hood AEG 8359 D. AEG 8359 D 18 pages. Fume extractor hood

Print Page

Installation - Fig. 3

Put the template onto the wall (1) and drill two Ø12mm holes (2).

Fit two hooks (3) on the drilled holes.

Hang the hood on the hooks and adjust the position of the hood

using the two screws on the bottom of the hooks (5).

Remove the metal filters (4) and mark two points (6). Remove the

hood and drill two Ø8mm holes on the marked points.

Fit two Ø8mm wall dowels (7), Hang again the hood and fix the

hood definitively with two screws 5X45 (8).

Fix the chimney support (10) with two screws 5 x 45 mm (9) and

two wall dowels (11) on the wall close to the ceiling.

For exhausting version: Fit the connection ring (S) on the top of

the hood with two screws Ø 3,5 x 6,5 mm (12S) then fit an

exhausting pipe long enough to reach the outside (13S).

For recycling version: Fix definitively the deflector (13K)

on the top of the hood with two screws Ø 3,5 x 6,5 mm

(12K).

Prepare the electric connection (14) (see relative chapter).

Fit the chimney (15) and fix it on the chimney support with two

screws 3,0 x 9 mm (16).

The lower part of the chimney must be slided down and inserted

on the housing on the upper part of the hood (18).

Fit the two grids (17) on both sides of the chimney.