A-Neuvideo ANI-7251TX Instruction Manual - Page 8

Browse online or download pdf Instruction Manual for Extender A-Neuvideo ANI-7251TX. A-Neuvideo ANI-7251TX 12 pages. Hdmi over cat5e/6/7 extender w/ lan/ir/rs-232/poe transmitter & receiver

Print Page
A
NEUVIDEO
Receiver
front
DC 48V: IR2 BLASTER:
q
of the equipment to be controlled.
IR1 EXTENDER:
Connect to the supplied IR Extender cables for IR signal reception. Ensure that remote being used is within the direct
w
line-of-sight of the IR Extender.
CAT5E/6/7:
Connect to the Transmitter unit with a single CAT5e/6/7 cable for transmission of all data signals.
e
HDMI OUT:
Connect to a HDMI equipped TV/monitor for display of the HDMI input source signal.
r
STD/UPDATE SWITCH:
t
RS-232 OUT:
Connect to the device that is to be controlled (via D-Sub 9-pin female cable) by RS-232 commands.
y
LAN:
Connect to a PC or Laptop to utilize the Internet or network function.
u
POWER LED:
This LED will illuminate when the device is connected to a power supply.
i
LINK LED:
This LED will illuminate when both Transmitter and Receiver are connected through CAT cable. When it blinks regularly
o
it states the Receiver is NOT sending signal but the Transmitter and Receiver are linked and if it blinks irregularly it states an error has
occurred.
Connect to the supplied IR Blaster cable for IR signal transmission. Place the IR Blaster in direct line-of-sight
This switch is reserved for factory use only.
Operation controls & Functions
back
6