Kohler 76399T Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Bathroom Fixtures Kohler 76399T. Kohler 76399T 2 pages. Multifunction handshower with hose & bracket-geometric

Print Page

INSTALLATION

1266877-2A-B

How to Install the Bracket

Determine a suitable location on the

finished wall to install the bracket, make

sure it should avoid buried cables and

pipes in the wall.

Mark bracket base mounting hole

locations on the wall according to the

dimension. Drill two holes in the finished

wall, the holes should match the

anchors(1) and be vertically. Install the

anchors. Tighten screws(3) to fix bracket

base(2) on the finished wall. NOTE: The

bracket base direction as shown.

Loosen the screw(6) in the bottom of the

bracket(4) with the hex wrench(5), make

the bracket can be installed. Apply a ring

of plumber putty or other sealants around

①

the underside of the bracket. Put the

bracket onto the bracket base and lock

them by screw and hex wrench.

Remove any excess putty.

How to Install the Handshower

and Hose

for about one

Flush both water supply

minute before the handshower(7) is

installed.

Put the screen washer(8) into the shower

hose(9) connector. Connect the

handshower to shower hose. NOTE:

Don't over tighten.

Install check valve(10) and into the

handshower inlet if needed.

②

Hang the handshower on the shower

bracket. Connect another end of shower

hose to the water supply.

Katalyst

Intense Massage

How to Operate the Handshower

Press the buttons of the handshower to

change the water flow.

CLEANING INSTRUCTIONS

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft

cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could adversely

affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler faucets and fittings.

1266877-2A-B

Champagne

How to Maintain the Handshower

Any debris or mineral build-up may cause the flow stream to become

distorted or reduce the flow rate. To remove the debris or mineral

build-up, run water through the handshower, firmly press or rub your

finger back and forth across the rubber nozzles.

Remove and clean the screen washer.