Kohler BodySpa K-1000 Installation Instructions Manual - Page 23
Browse online or download pdf Installation Instructions Manual for Bathroom Fixtures Kohler BodySpa K-1000. Kohler BodySpa K-1000 28 pages. Tower custom hydro-massage system
Also for Kohler BodySpa K-1000: Homeowner's Manual (48 pages)
Print Page
13. INSTALL THE SEAT
Remove the thumb screw, stainless steel washer, and
rubber washer from the seat.
Slide the seat onto the bracket as shown.
Install the stainless steel washer, then the rubber washer
onto the thumb screw. Insert the thumb screw through the
bracket's center slot and into the threaded hole in the seat
channel. Securely handtighten the thumb screw.
14. WATER TEST FOOTBATH AND TOWER
Make sure all PVC union connections are securely hand
tightened.
Fill the BodySpa to the bottom of the drain overflow.
Remove the motor/control access panel. Run the
BodySpa for 5 minutes and check the visible harness
(piping) and union connections for leaks.
Turn off the BodySpa.
Open the tower, and inspect all piping connections for
leaks.
Close the tower. Thread in and securely tighten two 3/8"
bolts. Do not overtighten.
For additional information on BodySpa operation, see
Start-Up BodySpa instructions on Page 24.
15. CLEAN-UP AFTER INSTALLATION
When cleaning up after installation, do not use abrasive
cleansers as they may scratch and dull the footbath
surface. Use warm water and a liquid detergent to clean
the surface.
Kohler Co., Kohler WI U.S.A.
Stainless Steel
Washer
Bracket
Stubborn stains, paint, or tar can be removed with
turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in contact
with footbath surfaces for long periods of time.
Plaster can be removed by scraping with a wood edge. Do
not use metal scrapers, wire brushes, or other metal tools.
A powder-type detergent may be used on a damp cloth to
provide mild abrasive action to the residual plaster.
23
Thumb Screw
Rubber Washer
Seat
AB
116290-2-