AEG 7000 Series User Manual - Page 42

Browse online or download pdf User Manual for Dryer AEG 7000 Series. AEG 7000 Series 49 pages.
Also for AEG 7000 Series: User Manual (32 pages), User Manual (44 pages), User Manual (32 pages), User Manual (28 pages), User Manual (36 pages)

Print Page

www.aeg.com

The appliance does

not fill with water

properly.

The appliance does

not drain the water.

The appliance door is

open or not closed

correctly.

No communication

between electronic el-

ements of the appli-

ance.

The mains supply is

unstable.

The anti-flood device

is on.

If the display shows other alarm codes, deactivate and activate the appliance. If the

problem continues, contact the Authorised Service Centre.

In case of different problem with the washing machine check the table below for possible

solutions.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not too low.

For this information, contact your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the inlet hose has no kinks, damages or bends.

• Make sure that the connection of the water inlet hose is cor-

rect.

• Make sure that the filter of the inlet hose and the filter of the

valve are not clogged. Refer to 'Care and cleaning'.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Make sure that the drain filter is not clogged. Clean the filter, if

necessary. Refer to "Care and cleaning".

• Make sure that the connection of the drain hose is correct.

• Set the drain programme if you set a programme without

drain phase.

• Set the drain programme if you set an option which ends with

water in the tub.

• Make sure that the door is properly closed.

• The programme was not finished properly or the appliance

stopped too early. Switch the appliance off and on again.

• If the alarm code appears again, contact the Authorised Serv-

ice Centre.

• Wait until mains supply is stable.

• Disconnect the appliance and close the water tap. Contact the

Authorised Service Centre.