Kohler K-1194 Installation Manual - Page 11

Browse online or download pdf Installation Manual for Bathroom Fixtures Kohler K-1194. Kohler K-1194 48 pages. Bath whirlpool
Also for Kohler K-1194: Homeowner's Manual (32 pages), Installation Manual (44 pages), Installation Manual (48 pages)

Print Page

Install a GFCI-protected 120 V, 15 A grounded outlet. Install a second

GFCI-protected outlet for "H" models for the heater.

Optional Heater (models may vary)

either T-style (shown) or water intake

(not shown).

Make sure air actuator tubing is securely

attached to the pump or the optional timer box.

NOTE: Pump model illustrated may differ from your actual product.

9. Make Electrical Connections

WARNING: Risk of electric shock. Make sure the power has been disconnected before performing the

following procedures.

WARNING: Risk of electric shock. To reduce the risk of electrical shock, connect the pump and in-line

heater (if heater option included) to properly grounded, grounding-type receptacles protected by

Ground-Fault Circuit-Interrupters (GFCI's). Do not remove the plugs' grounding pins. Do not use

grounding adapters.

Pump Wiring

NOTE: The whirlpool model number is printed on a label near the whirlpool pump. This label also

identiﬁes the electrical rating of the whirlpool.

Your Kohler whirlpool bath is equipped with a cord and plug. All wiring of the pump and control

has been completed at the factory. A licensed electrician must install a GFCI-protected, 120 V, 15 A,

grounded outlet. No other load should be on this circuit. Locate the outlet behind the whirlpool,

and within 24" (61 cm) of the pump.

Plug the pump into this outlet.

NOTE: Make sure the air actuator tubing is securely attached to the pump, and is not kinked or damaged.

If a K-1639 Timer Kit will be used, install it now according to the instructions packed.

In-line Heater Wiring

"H" Models: The heater is equipped with a cord and plug. All wiring of the heater has been

completed at the factory. A licensed electrician must install a GFCI-protected, 120 V, 15 A, grounded

outlet. No other load should be on this circuit. Locate the outlet behind the whirlpool, and within

24" (61 cm) of the heater.

Plug the heater into this outlet.

Kohler Co.

Bond in accordance with applicable codes.

Plug pump and heater into

these outlets.

1055820-2-A