AEG TR9MUNCHEN User Manual - Page 24
Browse online or download pdf User Manual for Dryer AEG TR9MUNCHEN. AEG TR9MUNCHEN 36 pages.
Print Page24
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• The water from the water container
can be used to iron the clothes. You
must first filter the water to eliminate
remaining textile fibres (simple coffee
filter is suitable).
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
10.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Select 1 of the available
programmes.
3. Touch and hold down the Droogtijd
and + Anti-kreuk buttons at the
same time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness
4. Touch the Start/Pauze button
repeatedly until you reach the
desired dryness level.
Dryness
level
Maximum
dryness
Extra dry‐
ness
Standard
dryness
5. To memorise the setting touch and
hold down the Droogtijd and + Anti-
kreuk buttons at the same time for
approximately 2 seconds.
Display symbol
In case of Wi-Fi network
connected machines a
ProSense bars animation is
performed for a few seconds
to indicate that your
appliance is updating data to
the Cloud.
If instead the mode is
changed with knob rotation
or switching off the machine,
the data synchronization will
be done during the first Wi-Fi
reconnection.
10.3 Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Select 1 of the available
programmes.
3. Touch and hold down Stil and
Opfrissen buttons at the same time.
One of 2 configurations is possible:
• the watertank indicator:
the symbol
water container indicator is
permanently activated
• the watertank indicator:
the symbol
water container indicator is
permanently deactivated
10.4 Operating hours counter
This function gives a possibility to display
the total operating time of the appliance
in hours, which is counted from the
moment it is first switched on. The actual
operating time of the cycles is shown
(does not include pauses or delayed start
time).
To visualise this value, proceed as
follows:
is on if
appears - the
is off if
appears - the