Kohler Symbio K-1335-H Installation Manual - Page 9

Browse online or download pdf Installation Manual for Bathroom Fixtures Kohler Symbio K-1335-H. Kohler Symbio K-1335-H 32 pages. Bath whirlpool

Print Page

15. Test Run the Whirlpool

- Check all electrical connections, and make sure the electrical power to the whirlpool is turned on.

- Make sure all union connections to the pump are securely hand tightened.

- Verify that the pump banding straps have been cut, and that the pump base is resting directly on the subfloor.

- Fill the whirlpool to a level at least 2" (5cm) above the top of the highest jet.

- Operate the whirlpool for 5 minutes, and check all whirlpool piping connections for leaks.

- For additional information on whirlpool operation, see Confirm Proper Operation on Page 10.

- If you have not already done so, carefully remove the protective tape from the whirlpool rim.

- Cover the framing with water resistant wall material. Seal the joints between the whirlpool rim edge and the

water resistant wall material with silicone sealant.

- Tape and mud the water resistant wall material. Install the finished wall to the water resistant wall material. Seal

the joints between the whirlpool rim and the finished wall material with silicone sealant.

- Install the faucet trim according to the instructions packed with the trim.

- When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the whirlpool

surface. Use warm water and a liquid detergent to clean the surface.

- Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners containing

petroleum distillates to remain in contact with any whirlpool surfaces for long periods of time. Remove plaster

by carefully scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. Use a

powder type detergent on a damp cloth to provide mild abrasive action to any residual plaster.

Kohler Co.

Water-Resistant

Wall Material

Finished Wall

Whirlpool

Framing

Apply silicone

sealant to the joint

between the

whirlpool and the

finished wall

1012312-2-