Kohler K-1111-H2 Homeowner's Manual - Page 6

Browse online or download pdf Homeowner's Manual for Bathtubs Kohler K-1111-H2. Kohler K-1111-H2 49 pages. Whirlpool
Also for Kohler K-1111-H2: Roughing-In Manual (4 pages), Roughing-In Manual (4 pages)

Print Page

Operation

NOTE: Please read these steps carefully before operating your whirlpool.

NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will

automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the

water cools.

Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.

Close the drain and ﬁll the bath to a level at least 2" (5.1 cm) above the top of the highest jet.

Place your hand in the bath to test the water temperature for comfort and safety, then carefully

enter the bath.

Press the power icon. The heater will turn on and the whirlpool will start at a medium water ﬂow

volume. Three small lights near the whirlpool ﬂoor will illuminate until the keypad goes into sleep

mode.

Press the up or down arrow to increase or decrease the water ﬂow volume. The indicator bar in the

center of the keypad will display the current water ﬂow volume.

Rotate the jet trim clockwise to reduce the air/water ﬂow or counterclockwise to increase the

air/water ﬂow.

Position the Flexjet nozzles to direct the water ﬂow to maximize your hydro-massage experience.

Rotate the outer ring until the heater mode is ﬂashing, then press OK. The heater will turn off. Press

OK again to turn the heater back on.

Press the power icon to turn the whirlpool off. The three small lights near the whirlpool ﬂoor will

remain illuminated until the keypad goes into sleep mode.

Repeat the steps above to verify the second keypad is operating properly, less the chromatherapy

functions.

NOTE: The whirlpool will automatically shut off approximately 20 minutes after continuous operation. If

desired, press the power icon to reactivate the whirlpool.

Care and Cleaning

For best results, keep the following in mind when caring for your KOHLER product:

• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.

• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and

dry any overspray that lands on nearby surfaces.

• Do not allow cleaners to soak on surfaces.

1042951-5-D

Fill with water 2" (5.1 cm)

above the highest jet.

Turn the Flexjet

trim clockwise to

decrease the flow.

Position the jet nozzles

to direct the water flow

as desired.

Turn the Flexjet trim

counterclockwise to

increase the flow.

Kohler Co.