Kohler K-1112 Installation Manual - Page 11

Browse online or download pdf Installation Manual for Bathtubs Kohler K-1112. Kohler K-1112 44 pages. Bath with airjets
Also for Kohler K-1112: Homeowner's Manual (32 pages), Homeowner's Manual (29 pages), Manual (4 pages), Installation Manual (48 pages), Homeowner's Manual (36 pages), Roughing-In Manual (4 pages), Installation Manual (48 pages), Installation Manual (44 pages), Homeowner's Manual (29 pages)

Print Page

Turn the jet trim ring

clockwise to

decrease the flow.

Turn the jet trim ring counterclockwise

to increase the flow.

9. Test Run the Whirlpool

Check all electrical connections, and make sure the electrical power to the whirlpool and heater (if

equipped) is on.

Make sure all union connections to the pump and heater are securely hand tightened.

Verify that the pump banding straps have been cut (if applicable), and that the pump is resting

directly on the subﬂoor or whirlpool base.

Fill the whirlpool to a level at least 2" (5.1 cm) above the top of the highest jet.

Operate the whirlpool for 5 minutes, and check all whirlpool piping connections for leaks.

For additional information on whirlpool operation, refer to "Conﬁrm Proper Operation".

Kohler Co.

Fill with water 2" (5.1 cm)

above the highest jet.

Position the jet

nozzles to direct

the water flow as

desired.

Press the air actuator to turn

on and off the whirlpool.

1010914-2-D