Kohler CABERNET WATER-GUARD K-3401 Installation Instructions Manual - Page 4

Browse online or download pdf Installation Instructions Manual for Toilets Kohler CABERNET WATER-GUARD K-3401. Kohler CABERNET WATER-GUARD K-3401 8 pages. Vitreous china siphon vortex toilet

Assemble the retainers, washers, and nuts over the
exposed T-bolts. Handtighten the nuts, then tighten them
an additional 1/2 turn with a wrench.
If the T-bolts extend more than 1/4" over the top of the
nuts, cut off the excess and file the end. Wipe away any
residue. Install the bolt caps.
CAUTION: Risk of personal injury or product
damage. Overtightening may cause breakage or
chipping.
TO CONNECT SUPPLY SHUT-OFF VALVE
NOTICE: Read this section carefully before performing
these steps.
For installation of the supply shut-off valve, refer to the
installation instructions packed with the valve. Carefully
bend the tubing to fit.
Cut the end of the tubing 1/4" longer than the distance be-
tween the supply shut-off valve and the supply shank. Re-
move any burrs from the inside of the tubing.
Slip the coupling nut, compression nut, and ferrule onto
the tubing. Insert the tubing into the supply shut-off valve
and the supply shank, positioning the seal washer
(supplied) or the compression washer (not supplied), as
shown. Tighten the coupling nut to the supply shank.
Then tighten the compression nut to the supply shut-off
valve.
WARNING: Risk of external leakage. Do not
overtighten any of these nuts, or you may deform
the connections and cause leakage.
Attach the toilet seat according to the installation
instructions included with it.
Open the supply shut-off valve and check all connections
for leakage. If the connections have been properly
assembled, a slight retightening of the nuts should stop
any leakage.
AA
112037-2-
(A)
Fig. #6
Supply Shank
Seal Washer
Tubing
Coupling Nut
Compression Nut
Ferrule
Fig. #7
4
Nut
Washer
Retainer
Compression Washer
Tubing
Coupling Nut
Compression Nut
Ferrule
Supply Shut-Off Valve
Kohler Co., Kohler, WI