Kohler CACHET K-4636T-U Installation Instructions Manual - Page 4
Browse online or download pdf Installation Instructions Manual for Toilets Kohler CACHET K-4636T-U. Kohler CACHET K-4636T-U 7 pages.
Print Page
Assemble the bolt cap bases, washer,
and nuts on the exposed T-bolts.
Handtighten the nuts, then tighten
them an additional 1/2-turn.
CAUTION: Risk of personal
injury or product damage.
overtightening may cause
breakage or chipping of the
vitreous china.
If the T-bolts extend more than 6mm
(1/4") over the top of the nuts, cut off
the excess and file the end. Wipe
away any residue. Install the bolt caps.
TO CONNECT WATER
SUPPLY
* Flexible hose (not provided) are
recommended to connect the supply
line to the fill valve. If you use a rigid
connection(not provided), take care
not to apply side forces to the bottom
of the fill valve. Be sure the rigid
connection must be fit with supply line
completely to prevent damage shank
by forced connection.
IMPORTANT:
Before turning on the supply valve for the first
time, follow the steps below to clear sand, debris and rust
from the system:
Make sure water sure water supply is off. Remove valve END
by rotating it 1/8 turn counterclockwise.
While holding a container over the uncapped VALVE to
prevent splashing, turn water supply on and off a few times.
Leave water supply off.
Replace END by engaging lugs and rotating 1/8 turn
clockwise.
Make certain the top is turned to the locked
position. Valve may not turn on if top is not fully in the
locked position.
Turn on water supply. Check that water level is at the marked
water line.
Attach the toilet seat according to the
installation instructions included.
Open the supply shut-off valve and
check all connections for leakage. If
the connections have been properly
assembled, a slight retightening of the
nuts should stop any leakage.
1033005-T01-J
Bolt Cap*
*
Nut
Washer
Bolt Cap Base*
*
T-Bolt
T
Fig.#6
6
Supply Shank*
Supply Shut-Off Valve
Fig.#7
7
Check This Area
Fig.#8
8
-4-
T
*Supplied with toilet
*
T
(
6mm
(
)
)
1/8
1/8