Kohler Command Pro CH960 Owner's Manual - Page 10

Browse online or download pdf Owner's Manual for Engine Kohler Command Pro CH960. Kohler Command Pro CH960 21 pages. Horizontal/vertical shaft
Also for Kohler Command Pro CH960: Owner's Manual (8 pages)

Print Page

NOTE: To prevent extensive engine wear or damage,

always maintain the proper oil level in the

crankcase. Never operate the engine with the

oil level below the L mark or over the F mark

on the dipstick.

Drain Plug

Figure 12. Oil Drain Plug (Starter Side).

Drain Plug

Figure 13. Oil Drain Plug (No. 2 Side).

Change Oil Filter

The oil filter on most engines is located on top of the

crankcase between the cylinders. Some models use a

remote mounted oil filter. See Figures 14 and 15.

Replace the oil filter seasonally (150 hours), or at least

every other oil change (every 300 hours of operation).

Always use a genuine Kohler oil filter, Part No. 52 050 02-S.

Oil Filter

Housing

Figure 14. Engine Mounted Oil Filter.

Figure 15. Optional Remote Mounted Oil Filter.

Replace the oil filter as follows:

1. Before removing the oil filter, clean the area

around the oil filter and housing to keep dirt and

debris out of the engine. Remove the old filter. On

crankcase mounted oil filter housings, a spring

loaded inner cup allows automatic oil drainback

into the crankcase as the oil filter is removed.

Wipe off the surface where the oil filter mounts.

2. Drain the oil from the engine crankcase.

3. Allow ample time for the oil to drain from the

crankcase.

4. Reinstall the drain plug and torque to 21.4 N·m

(15.7 ft. lb.).

5. Apply a thin film of clean oil to the rubber gasket

on the new filter.

6. Install the replacement oil filter. Turn the oil filter

clockwise until the rubber gasket contacts the oil

filter housing (not inner cup), then tighten the

filter an additional 3/4 to 1 turn.

7. Fill the crankcase with new oil of the proper type

to the F mark on the dipstick.

8. Start the engine and check for oil leaks. Correct

any leaks before placing the engine into service.

Oil Filter

Check oil level to be sure it is up to but not over

the F mark.

Service Oil Cooler

Engines are equipped with an oil cooler mounted

under the No. 2 side cylinder shroud, separate from

the oil filter (see Figure 16).

Inspect and clean the oil cooler every 150 hours of

operation (more frequently under severe conditions).

Oil cooler must be kept free of debris.