Kohler Command Pro CV200 Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Engine Kohler Command Pro CV200. Kohler Command Pro CV200 48 pages.
Also for Kohler Command Pro CV200: Owner's Manual (8 pages)

Print Page

Air Cleaner

NOTE: Operating engine with loose or

damaged air cleaner components

could cause premature wear and

failure. Replace all bent or damaged

components.

NOTE: Paper element cannot be blown out

with compressed air.

Move bails on air cleaner cover down; remove

latches from under tabs on base; remove cover.

Precleaner:

1. Remove precleaner from paper element.

2. Replace or wash precleaner in warm water

with detergent. Rinse and allow to air dry.

3. Lightly oil precleaner with new engine oil;

squeeze out excess oil.

4. Reinstall precleaner over paper element.

Paper Element:

1. Separate precleaner from element; service

precleaner and replace paper element.

2. Install new paper element on base; install

precleaner over paper element.

Reinstall air cleaner cover and place latches

under tabs on base; lift up bails to secure cover.

Breather Tube

Ensure both ends of breather tube are properly

connected.

14 590 49 Rev. --

Air Cooling

Never operate engine with heat shields or

guards removed.

Proper cooling is essential. To prevent over

heating, clean screens, cooling ﬁ ns, and other

external surfaces of engine. Avoid spraying

water at wiring harness or any electrical

components. See Maintenance Schedule.

Repairs/Service Parts

We recommend that you use a Kohler

authorized dealer for all maintenance,

service, and replacement parts for engine.

To ﬁ nd a Kohler authorized dealer visit

KohlerEngines.com or call 1-800-544-2444

(U.S. and Canada).

Storage

If engine will be out of service for 2 months or

more follow procedure below.

1. Add Kohler PRO Series fuel treatment or

equivalent to fuel tank. Run engine 2-3

minutes to get stabilized fuel into fuel system

(failures due to untreated fuel are not

warrantable).

2. Change oil while engine is still warm from

operation. Remove spark plug(s) and pour

about 1 oz. of engine oil into cylinder(s).

Replace spark plug(s) and crank engine

slowly to distribute oil.

3. Store engine in a clean, dry place.

KohlerEngines.com

WARNING

Hot Parts can cause severe

burns.

Do not touch engine while

operating or just after stopping.