Kohler 10RESV Installation Manual - Page 18

Browse online or download pdf Installation Manual for Portable Generator Kohler 10RESV. Kohler 10RESV 48 pages. Residential/commercial generator sets
Also for Kohler 10RESV: Installation Instructions (2 pages)

Print Page

6. Remove the cap from the fuel selector valve. See

Figure 1-12. Insert a flat head screwdriver under

the lip of the cap and push it upwards. Keep the cap

close by as it is needed to switch fuels in the next

step.

1. Fuel selector cap

Figure 1-12 Cap Removal

7. See Figure 1-13. Use the cap in the orientation

shown to turn the selector valve to NG or LP. See

Figure 1-14 for valve positions.

1. Turn selector valve

Figure 1-13 Fuel Selection

Section 1 Installation

1. Fully left for LPG

2. Fully right for NG

3. Factory-set screw (Do not adjust!)

Figure 1-14 Valve Positions

8. Replace the cap.

9. Connect and turn on the fuel supply (ensure that

tp6879

the fuel supply matches the fuel setting).

10. Reconnect the generator set engine starting

battery leads, negative (--) lead last.

11. Reconnect power to the battery charger.

12. Reassemble the left side panel.

13. Start the generator set by pressing the RUN button

on the generator set controller.

14. Check for leaks using a gas leak detector.

15. Run the generator set and check the operation.

16. Press the OFF button to to shut down the generator

set.

Rating

Converting the fuel will change the generator set rating.

See the generator set specification sheet for ratings with

natural gas and LPG. When converting to LPG from

factory settings, order a new nameplate with the

updated rating and fuel information from an authorized

distributor/dealer, if necessary. Provide the following

information from the original nameplate:

D Model Number

tp6879

D Spec Number

D Serial Number

D Fuel (original and new)

D kW

tp6879

D kVA

D Amps

D Volts

D Hz

TP-6984

5/17a