Kohler OnCue Plus Installation Instructions Manual - Page 2
Browse online or download pdf Installation Instructions Manual for Portable Generator Kohler OnCue Plus. Kohler OnCue Plus 17 pages. Residential/commercial generator sets
Also for Kohler OnCue Plus: Quick Start Manual (21 pages), User Manual (44 pages)
Print Page
Safety Precautions
Observe the following safety precautions while
performing this procedure.
WARNING
Accidental starting.
Can cause severe injury or death.
Disconnect the battery cables before
working
on
Remove the negative (--) lead first
when disconnecting the battery.
Reconnect the negative (--) lead last
when reconnecting the battery.
Disabling the generator set.
cause severe injury or death.
generator set or equipment connected to the set, disable the
generator set as follows: (1) Press the generator set off/reset
button to shut down the generator set. (2) Disconnect the
power to the battery charger, if equipped. (3) Remove the
battery cables, negative (--) lead first. Reconnect the negative
(--) lead last when reconnecting the battery. Follow these
precautions to prevent the starting of the generator set by the
remote start/stop switch.
FCC Interference Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide
reasonable
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with
these instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to
2
the
generator
set.
Accidental starting can
Before working on the
protection
against
harmful
radio or television reception, which can be identified by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following
measures:
Reorient or relocate the receiving antenna.
D
Increase the separation between the equipment and
D
the receiver.
Connect the equipment into an outlet on a different
D
circuit from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
D
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions. (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
FCC Caution:
Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate
this equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. To avoid
the possibility of exceeding radio frequency exposure
limits, you shall keep a distance of at least 100 cm
(39.4 in.) between you and the antenna of the installed
equipment. This transmitter must not be co-located or
operating in conjunction with any other antenna or
transmitter.
The availability of some specific channels and/or
operating frequency bands are country-dependent and
are firmware-programmed at the factory to match the
intended destination.
accessible by the end user.
The firmware setting is not
TT-1618 6/14