a-TroniX 9885376 Instruction Manual - Page 10
Browse online or download pdf Instruction Manual for Extender a-TroniX 9885376. a-TroniX 9885376 15 pages.
Print Page
Instruction Manual
Jump starter Booster 12V 4000A
6. How to use the jump starter
Use the jump starter to start vehicles:
Check that the jump starter is switched off.
■
A mismatch between the voltage of the jump starter and the voltage of the vehicle
■
system can cause explosions, damage to the vehicle, to the device and to people.
Identify the vehicle's ground terminal; usually it is connected to the negative terminal.
■
Always connect the output conductor with red pliers (+) to the positive pole of the
■
battery and the output conductor with black pliers (-) to the vehicle ground.
Never reverse the polarity; Reversing the polarity can cause explosions, damage to the
■
vehicle, to the device and to people.
When the RED „Reverse" LED is switched on, it indicates that the polarity has been
■
reversed.
Disconnect the pliers from the vehicle and connect them correctly.
■
Make sure cables are out of reach of fans, moving parts, and the fuel line.
■
Press the START / STOP button, the blue LED will turn on and „STRT" will appear on
■
the display.
Start the engine within 30 seconds.
■
The jump starter switches off automatically after 30 seconds.
■
If it does not activate when the START button is pressed, the vehicle battery is likely to
■
have a voltage below 6 volts, which is necessary for the protections to activate. In this
case, you must switch to the „FORCED START" mode described in the next section in
order to be able to start the vehicle.
To switch off the device, press the START / STOP button.
■
First disconnect the output conductor from the vehicle ground with black pliers (-) and
■
immediately store it in its holder.
Then disconnect the output conductor from the positive pole (+) of the battery with red
■
pliers and also immediately store it in its holder.
If it is not possible to start the vehicle with the first few attempts, under no
■
circumstances should you continue with further attempts. Before restarting, the device
should rest for at least 3 minutes so that it is not damaged.
Charge the jump starter after each use.
■
Page 10
09/2021