A. & H. Meyer NET+ Instagrid 230 V-PowerPack Quick Manual - Page 2

Browse online or download pdf Quick Manual for Power distribution unit A. & H. Meyer NET+ Instagrid 230 V-PowerPack. A. & H. Meyer NET+ Instagrid 230 V-PowerPack 3 pages.

Print Page
NET+ Instagrid 230 V-PowerPack
QUICK GUIDE
3.1
INSTRUCTIONS FOR SAFE USE OF THE DEVICE
•
Do not open the device under any circumstances. Maintenance and repair may only be
carried out by trained personnel.
•
Do not change the operating elements and sockets of the device.
•
Do not short-circuit the outputs of the device.
•
Do not touch the electrical contacts of the device with fingers, tools or any other objects.
•
Do not use the device as a work surface, such as a provisional workbench for sawing.
•
Do not use the device if there is any external damage. This does not apply to damage to
the frame or the carry handle. In the event of any other damage, activate the transport
mode. Contact customer service immediately.
•
Do not immerse the housing of the device in water or mud.
•
In the event of a battery fire, extinguish the fire with water. If possible, cover the device
completely with water. Call the fire brigade and inform them that lithium-ion batteries are
on fire.
•
Fumes may be released if the device is damaged or used improperly. Exposure to these
fumes may cause irritation of the respiratory tract. In this case, ventilate the room and
consult a doctor in case of discomfort.
•
In case of improper use, the batteries inside the device may leak. In case of contact, rinse
off with water. If the liquid gets into the eyes, seek medical attention. Contact with battery
acid can cause skin irritation or burns.
•
Do not dispose of the device or the batteries it contains in a fire or hot oven and avoid
mechanically crushing or cutting the batteries, as this may result in fire or an explosion.
4.
COMMISSIONING
The device is shipped with a low level of charge.
Depending on the application, the device may
therefore need to be charged before it is used for the
first time.
Deactivate the transport mode and set the device to
standby mode by turning the rotary switch
to
(clockwise). The outputs
The AC charging input
not light up.
4.1
CHARGING
The rotary switch must be set to
cable to a wall socket via the AC charging input
the LED indicator
[5]
will light up green from left to right. The outputs
Permanently green LED segments indicate the current charging status. Each LED segment
corresponds to a 12.5 % increase in the battery charge. As soon as the device is fully charged,
all LED segments
[5]
will light up green for 10 seconds. If the device is already fully charged, all
LED segments
[5]
will light up green for 10 seconds as soon as the charging cable is plugged in.
[3]
[4 | 9]
are voltage-free.
[8]
is active. The LEDs
(standby mode). To charge the device, connect the charging
v.1.0
from
[5]
will
[8].
While the device is charging, all segments of
[4 | 9]
are voltage-free.
2