AAVIX GC-1032 Owner's Manual - Page 12

Browse online or download pdf Owner's Manual for Metal Detector AAVIX GC-1032. AAVIX GC-1032 15 pages.

Print Page

False signals can be caused by trashy ground, electrical



interference, or large irregular piece of junk metal.

False signals are usually broken or non-repeatable.



Adjusting SENSITIVITY

After you become familiar with how your detector works, it's

important to fine tune the sensitivity to get a good effect.

Press the touch button SENS on the panel. Then press + or - to

increase or decrease the sensitivity. The level will be displayed on

the LCD.

Note:

In order to detect the target deeply buried, you can adjust the

SENS to a high position. But not to set the level of SENS to Max

position, or the detector will receive interference and false signal

from broadcast antenna and other electronic lines. The detector will

have unstable and irregular indications.

Pinpointing The Target

Accurately pinpointing a target makes digging it up easier. But it takes

practice. We suggest you practice finding sample on your own property

before you search other locations.

Follow these steps to pinpoint a target.

1. When the detector detects a buried target, continue sweeping the

search coil over the target in a narrowing side-to-side motion.

2. Make a visual note of exact spot on the ground where the detector

beeps.

3. Stop the search coil directly over this point on the ground. Then

move the search coil straight forward away from you and straight

back towards you a couple of times.

4. Repeat steps 1~3 at a right angle to the original search line, Make a

mark of "X". The target will be directly below the "X" at the point of

the beep response.