AAVIX AGT3420 Owner's Manual - Page 12

Browse online or download pdf Owner's Manual for Snow Blower AAVIX AGT3420. AAVIX AGT3420 20 pages. 20 inch 15amp snow thrower

Print Page

Maintenance

WARNING: Make sure to turn off

the switch and disconnect the

extension cord before performing any

maintenance task on your snow

thrower.

General Maintenance Tips

1. Do not attempt to repair the

machine unless you have the proper

tools and instructions for disassembly

and repair of the machine.

2. Check bolts and screws at frequent

intervals for proper tightness to

ensure that the equipment is in safe

working condition.

3. After each snow removal session,

run the snow thrower for a few

minutes to prevent the auger from

freezing. Shut off the motor, wait for

all revolving parts to stop completely,

and wipe residual ice and snow off the

unit. Rotate the chute crank several

times to remove any excess snow.

4. Only use a cloth soaked with hot

water and a soft brush to clean the

snow thrower, never wet or spray

water on the machine!

5. Do not use detergent or solvents as

these could cause irreparable damage

to the snow thrower. Chemicals can

destroy the plastic parts.

6. To protect the snow thrower from

corrosion when storing for long

periods, lightly oil the metal parts.

7. Store the applicance in a dry area

out of reach of children.

8. For user's safety, worn or damage

parts must be replaced. Replace with

original replacement parts only. Parts

from another snow thrower may not

fit properly, causing an unsafe

situation.

Warning:

Do not spray the unit

with water. Ingress of water may

destroy the switch-plug combination

unit and the electric motor. Clean the

unit with a cloth, hand brush etc.

Expert inspection is required, do not

make any adjustment by yourself,

must contact to customer service

center:

a) if the snow thrower strikes an

object.

b) if the motor stops suddenly.

c) if the auger is bent (do not align!)

d) if the motor shaft is bent (do not

align!)

e) if a short-circuit occurs when the

cable is connected.

f) If the gears are damaged.

Replacing the Scraper Bar

1. Remove the screws that secure the

scraper to the snow thrower.(Fig.13)

Fig13

2. Install the new scraper bar and

fasten it securely to the snow thrower

with screws.