AVLink YX-1042 User Manual - Page 8

Browse online or download pdf User Manual for Matrix Switcher AVLink YX-1042. AVLink YX-1042 12 pages. Ypbpr matrix switching system

Print Page

YX-1042 Matrix Switching System—User Manual

5.0 YX Matrix Control Panel Operation

5.0.1 Installation

Before the installation, make sure the peripherals of all DVDs are grounded properly and turned

off.

1. Connect the YX-1042 video input RCA connector with RCA Video male to male cable from

DVD players.

2. Connect the YX-1042 audio input RCA connector with RCA audio cable from DVD players.

3. Connect the YX-1042 video output RCA connector with RCA Video male to male cable from

HDTV.

4. Connect the YX-1042 audio output RCA connector with RCA audio cable from HDTV or

audio amplifier

5. Connect the power adapter each side.

6. The 1 port red LEDs will light constatly. If not, please go back to check step 5.

7. Turn on the DVD players and HDTV and audio amplifier.

8. If the green on line LED doestn't light，it means the DVD player doesn't be connected or

doesn't turn on.

5.0.2 Front Panel Key Operation

Push the upper bottom 1 on the front panel, the output of OUTPUT 1 is the input of the first port

and the upper bottom 1 will light.

Push the upper bottom 2 on the front panel, the output of OUTPUT 1 is the input of the second

port and the upper bottom 2 will light.

Push the upper bottom 3 on the front panel, the output of OUTPUT 1 is the input of the third port

and the upper bottom 3 will light.

Push the upper bottom 4 on the front panel, the output of OUTPUT 1 is the input of the fourth

port and the upper bottom 4 will light.

Push the lower bottom 1 on the front panel, the output of OUTPUT 2 is the input of the first port

and the lower bottom 1 will light.

Push the lower bottom 2 on the front panel, the output of OUTPUT 2 is the input of the second

port and the lower bottom 2 will light.

Push the lower bottom 3 on the front panel, the output of OUTPUT 2 is the input of the third port

and the lower bottom 3 will light.

Push the lower bottom 4 on the front panel, the output of OUTPUT 2 is the input of the fourth

port and the lower bottom 4 will light.