Dexter Laundry COIN COMPACT DRYER Operator's Manual - Page 5

Browse online or download pdf Operator's Manual for Dryer Dexter Laundry COIN COMPACT DRYER. Dexter Laundry COIN COMPACT DRYER 17 pages.

Print Page

INSTALLATION AND OPERATING INSTRUCTIONS

This dryer may have been supplied as part of a washer/dryer stacked

appliance. If so, refer to the washer instructions for uncrating and hard

mounting the stacked unit to a concrete floor and observe the dryer clearances

listed below.

UNCRATING AND PLACING DRYER (Stand alone dryer unit):

Tools Required: ½ in. hex socket and ratchet driver, wood block 4 in. or 5 in. (102-127 mm)

thick, a knife and a groove joint pliers, which will open to 1 3/8 in. (35 mm).

1. Remove and discard stretch-wrap, posts, cap and inner packing.

2. The crate base is attached to the dryer by (4) cap screws driven upward from below the crate

base. Remove crate base from dryer, by tipping dryer sidewise and place block under crate base

rail in center of dryer. Using a ratchet and ½ in. hex socket, remove and discard (2) crating bolts

from side, which is raised. Remove block from under crate base. Repeat for other side.

3. Install the leveling legs, which are shipped inside the dryer drum. Using a walking motion,

move dryer sideways about 6 in. (152 mm) off crate base. Tip dryer up and place block under

edge of dryer. Thread two leveling legs about two-thirds into the T-nuts on the base from which

the crating bolts were removed. Remove block from under dryer.

With a walking motion move dryer completely off crate base. Discard crate base.

Tip dryer sidewise, as previously done, and place block under edge of dryer on raised side.

Thread leveling legs into nuts as was done for the first side.

Slide unit into position where it will be installed. Adjust leveling legs, using the groove joint

pliers, to level and align dryer with adjacent units.

DRYER INSTALLATION

1. CODE CONFORMITY: All commercial dryer installations must conform to the local and

national codes for the location of installation.

2. INSTALLATION CLEARANCES: This unit may be installed at the following alcove

clearance.

I. Left Side

II. Right Side 0

III. Back

IV. Front

18 in. (457 mm) clearance is necessary behind the motors to allow

servicing and maintenance.

48 in. (1220 mm) to allow use of dryer.