Dexter Laundry DCT30KC Series Operator's Manual - Page 4

Browse online or download pdf Operator's Manual for Dryer Dexter Laundry DCT30KC Series. Dexter Laundry DCT30KC Series 15 pages.

Print Page
INSTALLATION AND OPERATING INSTRUCTIONS

UNCRATING

1. Remove cardboard container and innerpack.
2. Complete the uncrating as described in the procedure listed on the instruction sheet taped to the loading door
glass.

FIELD ASSEMBLY

For secure packaging, the dryer is shipped with the tee, one part of the heat reclaimer, inside the lower service
door.
To install:
STEP 1.
Remove 4 metal screws from the bag in coin box. Go to the rear of the dryer and remove the tape holding the top
of the vertical 8" pipe.
STEP 2.
Install the tee into both the vertical pipe and the horizontal boot. Using the four pilot holes provided, drill 4 matching
9/64 inch (3.6) diameter mounting holes; 2 holes through the boot into the tee outlet, and 2 holes through the tee inlet
into the 8 inch vertical pipe. Install the 4 screws provided to secure the tee to the pipe and boot.
STEP 3.
Install your exhaust system to the tee. Tape all joints with 2" duct tape.
ALTERNATE INSTALLATION
If it is desired to have the dryer exhaust at a low level, the installation can be altered as shown in the following
illustration.
STANDARD INSTALLATION
TO BUILDING
EXHAUST
The installer should acquire a 6" dia. 90° elbow and 6" dia. straight pipe for the two areas shown in the alternate
installation.
The exhaust tee may be cut off on the long end to give an over all length of 14" (356). This allows you to come
vertically to the 6" elbow above. (The necessary pipe for the standard installation is included as shown.)
COMMERCIAL DRYER
4
ALTERNATE INSTALLATION
6" ELBOW
6" PIPE
TO BUILDING
EXHAUST