Aqua Creek Products F-411RPL-AT1-02 Manual - Page 4

Browse online or download pdf Manual for Lifting Systems Aqua Creek Products F-411RPL-AT1-02. Aqua Creek Products F-411RPL-AT1-02 16 pages. Ranger-at pool lift

Print Page

Anchor Installation: Core-Drill Retro-Fit

NOTE: FOR DECKS 6" THICK OR MORE, 2500PSI MINIMUM STRENGTH CONCRETE REQUIRED

You will need:

• Core drill and 1½" core drill bit

• Tape measure

• Marking pen

• Hammer

• Cold chisel

• Torpedo level

• High strength 2-part construction epoxy*

• Masking Tape

• Black electrical tape (optional)

• Anti-Seize packet

*Aqua Creek recommends either Hilti™ Brand HIT RE-500-

SD or Simpson™ brand SET-XP or equivalent

FIGURE 2

NOTE: Your local bonding regulations may require you to drill one hole larger than the others in order to bond at

least one of the anchor inserts. You may need to saw cut a portion of your deck.

See "Saw Cutting Retro-Fit Instructions" on page 6.

Remove the nuts and the black protective coverings from the threaded anchor inserts.

(not included)

Anchor jig plate with hardware

Mark the 4 hole locations on your deck using

the larger holes of the anchor jig plate as a

template. Make sure the center of the holes on

the anchor jig plate are 14.5 to 19 inches from the

pool's edge.

SEE FIGURE 2

Drill the 4 hole locations to about 4 1/2 inches

deep using the 1 1/2 inch drill bit. Make sure the

holes are completely dry and clear of debris.

NOTE: Create a depth marker on the drill bit with black

electrical tape to make sure you drill to the right depth.

Revised 6/1/18