Aqua Creek Products F-SCTXL-W Manual - Page 6

Browse online or download pdf Manual for Lifting Systems Aqua Creek Products F-SCTXL-W. Aqua Creek Products F-SCTXL-W 15 pages.

Print Page

HOLE 05

HOLE 04

FIG. 05

THE AQUA CREEK FOOTREST ASSEMBLY IS DESIGNED

TO FIT UNDER THE CHAIR AND IS INSTALLED INSIDE THE

2" SQUARE TUBING THAT SUPPORTS THE SEAT FROM

UNDERNEATH. TO INSTALL THE FOOTREST; FIG. 06

A INSERT THE FOOTREST ASSEMBLY INTO THE 2X2

SQUARE TUBING THAT SUPPORTS THE CHAIR UNTIL THE

PLASTIC INSERT OF THE FOOTREST ASSEMBLY SITS FLUSH

AGAINST THE END OF THE 2X2 TUBE.

B USING THE SUPPLIED

1/4" FASTENERS, FASTEN THE

LEG REST ASSEMBLY TO THE

2X2 TUBING IN THE DESIRED

LOCATION.

THE SEAT ASSEMBLY WILL ARRIVE ATTACHED TO THE

SEAT POLE ADJUSTED TO ITS HIGHEST POSITION (HOLE 05).

TO ADJUST THE SEAT ASSEMBLY TO A LOWER POSITION

REMOVE THE FASTENERS SHOWN IN FIG. 05. SLIDE THE

SEAT ASSEMBLY TO ITS DESIRED POSITION (4"

INCREMENTS) AND REINSTALL THE FASTENERS. THE

MAXIMUM ADJUSTMENT IS 16"

HOLE 03

DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THE

BOTTOM TW0 HOLES-ALWAYS USE THE TWO (2) SUPPLIED

BOLTS TO ATTACH THE SEAT ASSEMBLY TO THE SEAT POLE!

HOLE 02

NOTE: FOR MOST APPLICATIONS THE SEAT WILL BE

INSTALLED IN ITS LOWEST POSITION (HOLE 01). FOR

HOLE 01

APPLICATIONS WHERE A WALL OR CURB MUST BE CLEARED

THE SEAT SHOULD BE INSTALLED IN A HIGHER POSITION.

PRODUCT ASSEMBLY

Aqua Creek Products

FIG. 06

6/27/2022 8:55:18 AM PAGE - 6