AVM OVATION A 6.2 Operating Instructions Manual - Page 8

Browse online or download pdf Operating Instructions Manual for Amplifier AVM OVATION A 6.2. AVM OVATION A 6.2 14 pages.

Print Page

2 Basic operation

2.1 Gerät ein- / ausschalten

Using the power button (1) you can switch between on (operate) and stand by. When

switched on, the display (5) lights up and the LED (3) is off. In stand by mode the display is off

and the LED is on to indicate that the unit is still connected to mains.

CAUTION: When switched to stand by the unit is still connected to the mains. In case of a

thunderstorm or if you leave the house for a longer time we recommend that you switch off

the amplifier off by using the mains switch (23) or pull the mains plug.

Use the program selector (2) to select a signal source. The selected source is indicated in the

display (4).

Use the rotary encoder (6) to set the desired volume. Depending on rotating speed the

volume increases / decreases in 0.5 dB steps (slow) or 2 dB steps (fast). The actual setting is

shown in the display (5).

The level of signal sources differs often by several dBs. You recognize a step in volume, when

switching between two different inputs. With the sensitivity setting menu you can avoid this.

The sensitivity of each input can be adjusted between – 9.5 dB and + 10.0 dB.

Select any input and chose a convenient volume level. Now press the multifunctional button

4c under the display for more than 2 seconds. The button is now marked EXIT LVL. Now you

can switch between the sources and adjust the levels by using the volume knob (6). Pressing

this multifunctional button (4c) under the display again will exit the level setting mode and

bring the unit back to normal operating mode.

NOTE: While the level setting mode is active the unit will not respond to any remote control

commands.