AVM OVATION SA 6.3 Operating Instructions Manual - Page 9

Browse online or download pdf Operating Instructions Manual for Amplifier AVM OVATION SA 6.3. AVM OVATION SA 6.3 12 pages.

Print Page

2.4 Reset (Factory settings)

The Reset menu cancels certain or all settings and makes the unit return to default settings.

To enter the Reset menu, please switch off your device on the rear of the unit at the mains switch (13).

Keep the middle key under the display pressed (3) while you switch on the unit again (13). As soon as

the display shows the reset menu you can release the multifunctional button under the display (3). Now

press ALL to reset the unit completely. CANCEL will bring the unit back to normal operating mode

without resetting any item.

After resetting your MA / SA 6.3, the unit automatically switches to standby and will restart depending

on the selected operating mode (e.g. if a trigger voltage (10) is connected and the trigger mode is

selected - see section 2.3.3).

3 Appendix

3.1 Cleaning

Use a soft cloth and normal glass cleansing fluid.

CAUTION

Make sure no fluid gets into the unit. Do not use scouring cleaners. They may damage the surface.

Some putative defects are often caused by small mistakes in operation. Sometimes, other units

connected to the amplifier may cause problems, too. We therefore kindly ask you to read the following

tips first, before consulting your dealer or us.

1. No playback

a) First of all, please check whether the pre-amplifier and the selected signal source are operating

correctly. This is best achieved by checking the functioning of the pre-amplifier by using some

headphones. Remember to remove the headphones afterwards, otherwise the pre-amplifier will

not emit a signal to the MA / SA 6.3.

b) Ensure there are no breaks or short circuits in the signal cable between the amplifier and the pre-

amplifier.

c) Check the connecting cable between the amplifier and the loudspeakers for a short circuit or break.

d) Inadvertent switching to standby. Press the power button (1). If the LED indicator and display do

not light up, a fuse can be blown due to overvoltage (e.g. in case of a thunderstorm etc.). Please

contact your dealer.

2. The unit does not switch from STANDBY to OPERATE or switches while listening to music

from OPERATE to STAND BY

a) This can happen when the amplifier is operated in auto mode and you are listening at low levels.

Then the incoming voltage from the pre-amplifier is too low to trigger the auto-circuit. In this case,

we recommend to switch the unit to permanent mode or to make use of a trigger cable (see section

0).

b) If the unit is operated in trigger mode, please check the trigger cables between the pre-amplifier

and the amplifier and ensure there are no breaks or short circuits in the cable.

c) The unit is operated in remote mode without using a suitable pre-amplifier (such as an AVM SD or

PA model). Choose a different operating mode (see section 2.3.3).