AVM EVOLUTION CD 5.2 Operating Instructions Manual - Page 5
Browse online or download pdf Operating Instructions Manual for CD Player AVM EVOLUTION CD 5.2. AVM EVOLUTION CD 5.2 14 pages.
Also for AVM EVOLUTION CD 5.2: Operating Instructions Manual (14 pages)
Print Page16 Analogue output right (balanced, XLR)
17 Analogue outputs (RCA)
18 Analogue output left (balanced, XLR)
19 Digital output optical
20 Digital output coaxial
21 USB B digital input
22 Digital inputs optical
1.3 Installation and cooling
The unit can become warm depending on environmental temperature. Therefore it is important, that
the cooling air can flow unhindered into the air inlet in the bottom and flow out through the holes in the
rear panel. Direct exposure to sunlight is not recommended because this will heat up the unit and may
cause unwanted malfuctions.
1.4 Connection to mains
Connect the unit to the mains outlet by using the power cord which is (in some countries) delivered
together with the unit. Make sure that mains voltage is according to the value printed on the rear panel
of the amp (near mains connector).
CAUTION: Keep the unit switched off until all audio connections are made.
1.5 Connection to a preamplifier or integrated amplifier
Connect the analogue outputs (16-18) to the high level inputs of a preamplifier or integrated amplifier.
The RCA-cinch outputs and the balanced XLR outputs are fully decoupled from each other and can be
used independently.
1.6 Connection of digital sources
Digital sources
Connect the outputs of your digital sources to the corresponding inputs of your CD player:
- Optical inputs (22)
- Coaxial inputs (24)
- USB B input (21)
- AES/EBU input (26)
Digital out
The input of a digital recorder must be connected to the digital outputs (19, 20). The signal on the
digital outputs depends on the selected source (built-in CD, digital input).
1.7 RC 3 remote control
The included RC 3 remote control allows for easy and comprehensive control of the C 2.2. All main
functions of the C 2.2 can be controlled by the RC 3: on/off, source selection, station selection, SKIP,
PLAY/PAUSE, and STOP.
By pressing the PLAY button briefly a second time, the PAUSE function is activated while in CD mode.
By pressing the STOP button briefly a second time, an inserted CD is ejected. By holding down one of
the SKIP buttons a little longer, the device switches into seek mode (fast forward/reverse).
23 Configuration port (Updates)
24 Digital inputs coaxial
25 Connector for external IR receiver
26 Digital input AES/EBU
27 Trigger outputs
28 Mains connector
29 Mains switch
5