AVM OVATION CD 6.2 Operating Instructions Manual - Page 15

Browse online or download pdf Operating Instructions Manual for CD Player AVM OVATION CD 6.2. AVM OVATION CD 6.2 19 pages.
Also for AVM OVATION CD 6.2: Operating Instructions Manual (19 pages)

Print Page

3 Advanced Settings

3.1 Personal Setup

The personal setup offers a range of settings to individualize your device according to your

personal needs. To enter the personal setup menu, please switch off your device on the rear

of the unit at the mains switch (29). Keep the PROG button pressed (4) while you switch on

the unit again (29). As soon as the display shows the personal setup menu you can release

the PROG button (4).

When the personal setup is active, you can select the desired function using the option keys

(2, 3). Use the SKIP buttons (13, 14) to apply changes to a selected function. EXIT (STOP

button) exits the personal setup and stores all settings.

3.1.1

Set volume control

Gain fix

If the gain fix option is activated, the signal of the selected sound source will be played back

with a fixed volume level. This setting is particularly useful when your device is part of a

surround sound setup where a separate surround decoder is used for bass and multi-channel

management. If a surround system is connected to your device, specific settings such as

channel balance, tone settings and bass management are controlled by a separate decoder.

These settings may not be altered by other components in order to maintain the balance of all

channels. For this application, your device offers the gain fix function by passing through the

signal with a fixed gain setting (see below).

Gain variable

If the option Gain variable is activated, the playback volume can be controlled in steps of 0,5

dB by holding down one of the option keys on the front side of the unit (2, 3) for more than

one second. The current volume level is shown in the range of 0 to 100 dB in the upper part

of the display (see also section 2.6).

3.1.2

Set display brightness

Sets display brightness 25% to 100%.

NOTE: The setting 100% can lead to "burn in" effects on the display if the unit is operated in

this setting for a very long time. In order to avoid such "burn in effects" please switch the unit

to stand by, if not in use.