AVM INSPIRATION CS 2.2 Operating Instructions Manual - Page 7
Browse online or download pdf Operating Instructions Manual for Car Receiver AVM INSPIRATION CS 2.2. AVM INSPIRATION CS 2.2 20 pages. Compact streaming cd-receiver
Print Page1.13 Connecting the WLAN antenna
In order to use the WLAN connection of the CS 2.2, the included WLAN antenna needs to be installed.
Please align the antenna until straight and screw it on the antenna socket (15). Afterwards you can
adjust the angle of the antenna according to your needs.
2 Basic operation
2.1 First operation / self test
In case the CS 2.2 was not connected to mains a self test will be performed when it is switched on by
the mains switch (34) for the first time. The unit will check its configuration and if all installed
components work properly. The procedure is shown in the display. Afterwards the unit will switch to
stand-by.
2.2 Switching on / stand-by
Using the button power (1) You can switch between on (operate) and stand-by. In the on state the
display (3) lights up and the LED (2) is off. In stand-by mode the display is off and the LED is on to
indicate that the unit is still connected to mains.
CAUTION: When switched to stand-by the unit is still connected to mains. In case of a thunderstorm
or if you leave the house for a longer time we recommend that you switch the amplifier off by using the
mains switch (33) or pull the mains plug.
2.3 Selecting the signal source
The signal source can be selected by pressing the source selector (12) until the desired source
appears on the display. For selecting Tuner or CD, use the direct access keys 10 / 11.
CAUTION: If you switch to another source while playing a CD, the drive will stop first. This may take a
few seconds. If you activate a digital input that has no valid signal, "NO DIG SIGNAL" is indicated in
the display (3). In this case the source can not be changed.
3.4 Volume setting
Use the rotary encoder (14) to set the desired volume. Depending on rotating speed the volume
increases / decreases in 0,5 dB steps (slow) or 2 dB steps (fast). The actual setting is shown in the
display (3).
Please not that if the volume is changed using the RC 9 remote control, the level always increases /
decreases in 2 dB steps.
2.3.1 Setting of input sensitivity
The level of signal sources differs often by several dBs. You recognize a step in volume, when
switching between two different inputs. With the sensitivity setting menu you can avoid this. The
sensitivity of each input can be adjusted between – 9.5 dB and + 10.0 dB.
Select any input (but NOT the Tuner or CD) and chose a convenient volume level. Now press the
multifunctional button 6 under the display for more than 2 seconds. The button is now marked "EXIT
LVL". Pressing this button again will exit the level setting mode and bring the unit back to normal
operating mode.
7