AVMATRIX TS3019 User Manual - Page 9

Browse online or download pdf User Manual for Industrial Equipment AVMATRIX TS3019. AVMATRIX TS3019 14 pages. Wireless tally system

Print Page

2.DIP SW 3

This switch is used to select the input and output of the RS-485 interface.

When set to 1, RS-485 is selected as input, and when set to 0, RS-485 is selected as output.

The RS485 is configured as an output when a wired connection is required between the tally box and tally

lamp.

3.DIP SW 4

This switch is used to set the switch selection control between DIP and the PC software.

When set to 1, it works according to the current DIP configuration parameters; when set to 0, DIP

parameters are invalid and the built-in parameters configured by the PC software are used.

4.DIP SW 5

This switch is used to set the group of tally box.

When set to 1, group 1 is selected, and when set to 0, group 2 is selected.

Note: The transmitter and receiver of the same group should be set in the same cluster.

This function is used when more than one tally is needed to work at the same time on the same occasion

(within a 1km radius) to prevent the signals of different groups from interfering with each other. The

factory default is group 1. When the signal is not received, check whether the TX and RX group settings

are the same group. DIP can be configured for two groups, the software can be configured for up to 8

groups.

5.DIP SW 6

This switch is used to select the operating state of the USB-C interface.

When set to 1, USB-C interface is in working state, and when set to 0, USB-C interface is in configuration

state and used to connect to the computer to control the software configuration parameters.