Avnet ZUBOARD 1CG Getting Started Manual - Page 7

Browse online or download pdf Getting Started Manual for Single board computers Avnet ZUBOARD 1CG. Avnet ZUBOARD 1CG 14 pages.

Print Page

External USB C 15V power supply 45W USB C cable (recommending Advantech

•

PSA-A45WM-U)

Router or open Ethernet Port on host Windows PC

•

micro-USB cable

•

Ethernet cable

•

Example Design

The ZUBoard 1CG ships with an example FreeRTOS design stored in the QSPI. If the QSPI

has been erased or reprogrammed, then use the Restore QSPI Factory Images tutorial

available at Element 14 Avnet Boards Community to restore both the QSPI to the original

factory images.

Note: The factory test results are located in QSPI and can be exported from the out of box

example. Once the QSPI is erased or reprogrammed, this data is lost.

1. A terminal program is required. Tera Term was used in this example which can be

downloaded from the Tera Term project on the SourceForge page:

Install Tera Term or another terminal program of your choice to a host Windows PC.

2. When you Connect the ZUBoard 1CG micro-USB JTAG/UART port J16 to your host

Windows PC. It should automatically install the proper drivers, giving you a confirmation

as shown below. If installed correctly, skip to Step 6.

Figure 2 – ZUBoard 1CG USB-JTAG/UART Installed Correctly

3. In the rare circumstance that the drivers are not auto installed, then you must manually

install the driver for the FTDI FT2232H device. Visit the FTDI website and download the

appropriate driver for your operating system.

4. Make sure the ZUBoard 1CG is unplugged from the PC. Unzip and install the driver.

5. Reboot your PC then plug in the ZUBoard 1CG.

6. Ensure the BOOT MODE switch (SW2) is set to QSPI (On-OFF-ON-ON).

http://www.ftdichip.com/Drivers/VCP.htm

Page 7

ttssh2.sourceforge.jp