Aqua Lights AL250MH Installation And Maintenance Instruction Manual - Page 4

Browse online or download pdf Installation And Maintenance Instruction Manual for Light Fixture Aqua Lights AL250MH. Aqua Lights AL250MH 14 pages. Underwater hull light

Print Page

attempting to open the housing.

• Using your hand, loosen the rear lock ring, (turning counter clockwise).

• Once the ring is free, carefully withdraw the lamp assembly from the housing.

• NOTE: Ensure the area local to the light is relatively dry, thus ensuring bilge water can not enter the opened housing. Also ensure

the withdrawn lamp assembly DOES NOT comes in contact with water at any time. It MUST remain clean and dry at all times. Should

the assembly come in contact with water, contact your nearest supplier for further advice. Do not re-assemble and re-energize.

• Hold the cable end of the lamp assembly and rotate (counter clockwise) the reflector case. Unscrew until the lamp is exposed.

• Carefully withdraw the spent lamp from its socket. It is recommended to use a glove or thick cloth as the lamp may shatter causing

injury.

• Inspect the lamp socket carefully for any signs of damage or corrosion. Basic cleaning may be carried out using dried, compressed

air. DO NOT spray contact cleaner into any part of the lamp holder assembly.

• Carefully remove new lamp from its packing. Using a clean cloth, fit the new lamp into the

lamp is wiped totally clean of any dirt or fingerprints. Failure to do so will result in premature lamp burn-out.

• Inspect the housing to ensure it is completely clean and dry. The lens may be cleaned if necessary using a soft cloth on the end of a

wooden dowel or similar. Re inspect after cleaning to ensure no cloth or other cleaning fibers remain inside the housing. NEVER!

Spray lubricants, degreasing agents or other similar products into the housing. Carefully re-fit the lamp assembly into the housing

ensuring the front end of the reflector case locates correctly into the front end of the lamp housing. This can be felt by moving the

assembly around until it drops neatly into position with the rear end cap snug against the silicone seal.

• Re-fit the outer lock ring. Again it is recommended to apply a thin layer of silicone based grease to the thread and surface in

contact with the end cap.

• NOTE: at no point is it necessary to loosen the cable gland nut; however it should be checked to insure it is secure and snug around

cable, DO not pull excessively on the cable.

•

Check to ensure the underwater lens is clean and free of marine growth. It may be cleaned using a nylon brush or plastic

scraper.

•

Replacement parts and accessories: A full range of Replacement parts and accessories are available. Please contact your

supplier for any requirements.

•

Should there be a malfunction for any reason, please consult your nearest agent or Aqua Lights directly. The housing should not

be opened under any circumstances unless by a suitably qualified and authorized technician.

Safety and General Information

Other Maintenance

Socket. IMPORTANT! Ensure the new