ALLIED ELECTRONICS NeXGen Prime User Manual - Page 5

Browse online or download pdf User Manual for Controller ALLIED ELECTRONICS NeXGen Prime. ALLIED ELECTRONICS NeXGen Prime 9 pages. Forecourt controllers

Print Page

1.3 FCC Warning

This equipment generates, uses, and can radiate radio frequency energy and if not

installed and used in accordance with the instruction manual, may cause interference to

radio communications. It has been tested and found to comply with the limits for a Class

"A" computing device pursuant to Subpart B of Part 15 of the FCC Rules, which are

designed to provide reasonable protection against such interference when operated in a

commercial environment. Operation of this equipment in a residential area is likely to

cause interference, in which case the user, at his own expense, will be required to take

whatever measures may be required to correct the interference.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

1.4 PCI PA-DSS

The NXG-P forecourt controller executing the ANDI-based firmware is a PCI PA-DSS validated

payment application. As such, it must be deployed in accordance with the PCI PA-DSS

guidelines.

Allied Electronics provides an Implementation Guide to aid in this process. See PA-DSS

considerations for Installation and Maintenance Personnel.PDF available from Allied Technical

Support or through the Allied Sharefile site.

1.5 Installation Environment

1. The Allied Electronics NXG-P Controller operates on 115 VAC @60Hz, 36 Watts. The NXG-

P controller is supplied with approximately 8 feet of 115 VAC power cord, and should be

connected to an approved isolated ground receptacle on its own dedicated circuit. The controller

must be installed in a temperature-controlled environment (between 32

2. The controller must be installed in accordance with the National Electrical Code (NFPA 70),

the Automotive and Marine Service Station Code (NFPA 30A), and all state and local electrical

codes.

3. The controller must be installed indoors, above the Class 1, Division 2 Hazardous location.

4. The controller is designed for use with peripheral devices that are UL Listed.

Page 5 of 9

F and 100

F).

User Manual