CP Electronics MWS3A-PRM-L3 Product Manual - Page 3
Browse online or download pdf Product Manual for Security Sensors CP Electronics MWS3A-PRM-L3. CP Electronics MWS3A-PRM-L3 8 pages. Ceiling microwave detector with 3m pre-wired lead
Print PageChoosing a Suitable Location
The detector should be sited so that the occupants of the room fall inside the detection pattern shown opposite).
•
Avoid positioning the unit where direct sunlight may enter the sensor element.
•
Do not site the sensor within 1m of any lighting, forced air heating or ventilation.
•
Do not fix the sensor to an unstable or vibrating surface.
•
Avoid metallic objects directly in front of the sensor head.
When power is applied to the unit, the load will turn on immediately.
Set the timeout to 10 seconds, vacate the room or remain very still and wait for the load to switch off .
Check that the load switches on when movement is detected.
The unit is now ready for programming.
The UNLCDHS has the ability to read back the settings stored in a device.
To read back individual parameters
•
Navigate to the parameter and press the 'R' (Read) button whilst pointing at the device. The handset will click
when the parameter has been read back, the device will flash its LED, and the value will be shown against the
parameter in the menu.
To read back all of the parameters in a menu
•
Press and hold the 'R' (Read) button for more than 1 second.
•
The handset will click every time a parameter is received
•
The device will show multiple flashes of its LED
•
All of the values will be shown against the parameters in the menu.
•
The individual parameters may be edited and then saved as a 'Macro'.
Notes
•
If a parameter(s) has been missed because of a communication error, the missing value(s) is replaced by dashes.
•
When reading back, the Channel 1 relay (where fitted) will temporarily be switched off, and will return to it's
normal state 2 seconds after the read back has been completed.
Readback function
Installation
Power-up test procedure
(UNLCDHS handset only)
3