Billi Sahara Plus User Manual - Page 8
Browse online or download pdf User Manual for Plumbing Product Billi Sahara Plus. Billi Sahara Plus 12 pages.
Also for Billi Sahara Plus: Installation Manual (8 pages), Install Manual (7 pages)
Print Page
User guide
Billi Sahara & Sahara Plus.
Filter removal and
replacement instructions
Important note: Please ensure you remove the
foam packing under the filter before installing .
1 . Remove the front panel .
2 . Place the unit in Holiday Mode by pressing
the Pressure Relief button once . The lights
on the dispenser will alternate and then go
off
3 . Hold filter and swing towards you slowly .
The top of the filter is in a hinged cradle
assembly . It should stop after approximately
30 degrees of travel .
4 . The filter can now be released from the
holding cradle by pulling down on the filter .
5 . Take care not to spill water in the base of the
tray . If so wipe gently with absorbent paper .
6 . Install new filter into the same location
by pushing all the way up into the cradle .
7 . Push filter back into the unit until it locks
into place . Power light should come back on .
8 . Lift cold lever and run until water flow stops .
Close cold lever and wait for 10 minutes .
Lift cold lever and run until water stops .
Close cold lever .
9 . Check for any leaks from around the filter,
hosing or pipeworks .
10 . Replace the front cover .
8