Billi XI Font Installation Manual - Page 3

Browse online or download pdf Installation Manual for Plumbing Product Billi XI Font. Billi XI Font 8 pages. Proud & flush mount

Print Page

Installation procedure.

Proud Mount
1. Marking and Drilling Holes
a. Cut the template out and place template
in appropriate position. Check underneath
benchtop for possible obstructions such
as dividers, existing plumbing, etc. Trace
round the template and drill a pilot hole
for the jigsaw, using the jigsaw follow the
line in which was traced onto the bench
– see diagram 7 on next page.
2. Fitting Drain Adapter
a. Fit O-ring to Drain adapter.
b. Fit Drain adapter to tray. Tighten M5
screw, Note: Do NOT over-tighten
the screw.
c. Drain tube and elbow fitting are to
face dispenser mount hole – refer to
diagram 1 on previous page.
3. Fitting Billi Font to Benchtop
a. Ensure silicone bead is installed around
the edge of the cut out – ref to diagram 2.
b. Lower the Font tray into the cut out and
insert 4 x M6 bolts, one in each corner.
c. Fit the clips and M6 Flange nuts to all 4
bolts – refer to Diagram 3.
e. Tighten nuts until rim sits flat on
benchtop. Do NOT over-tighten nuts.
4. Fit front and rear cover plates
a. Remove protective film from cover
plate set.
b. Remove gasket cover and insert cover
into font tray.
c. Ensure holes in rear cover plate align with
the holes in the font tray.
d. Apply pressure around edge of plate(s)
to ensure proper gasket seal.
5. Fitting Dispenser Riser – refer to diagram 4.
a. Screw 3 x M4 studs into the rear
of the riser.
b. Fit the Gasket over the studs.
c. Place the riser through the cover plate
and into position on the font.
d. Fit and tighten 3 x M4 Flange nuts
to the underside of the Font tray.
6. Fitting Dispenser Head Assembly
(refer to diagram 5)
a. Feed dispenser tubing and loom
through centre hole in riser
in the following order:
i. Dispenser power cord
ii. Grey vent silicone tube. Feed tube until
reducing join passes through Mount
riser assembly – see diagram 5.
iii. Red and blue silicone tubing. Check
tubing is not kinked or twisted.
b. Turn dispenser head to 60° from the
straight ahead position of mount base.
Slide head assembly onto base assembly
whilst gently pulling tubing downwards
from underneath. Dispenser mounting
lugs will pass over and slide down the 3
grooves on the swivel bearing.
c. Once fully down, turn dispenser head to
straight ahead position. Fit M4 x 10mm
retaining screw rear threaded hole and
tighten with
Allen Key supplied.
7. Connect Tubing to Underbench Module
a. Connect dispenser tubing to underbench
module as per installation instructions
supplied with your unit.
8. Connect Drainage
a. Connect drainage tubing with reference
to Drainage Requirement instructions
on previous page. Drainage tube must
be installed with a continual fall along
the entire length of the tube and must be
adequately clipped and supported.
Bench
Clip
Bench
Seal between
Font and Benchtop
Diagram 2
Riser
Font tray
Bench
M6
Bolt
Diagram 3
291mm
Font tray
3 x M4 studs
Gasket
Font tray
3 x M4 nuts
Diagram 4
Nut
Swivel
bearing
Mount riser
Gasket
Font tray
Diagram 5
191mm
Diagram 6
3