Allied Telesis AR400 Series Safety Information Manual - Page 4

Browse online or download pdf Safety Information Manual for Switch Allied Telesis AR400 Series. Allied Telesis AR400 Series 18 pages. How to set up pppoe between a linux client and access concentrator
Also for Allied Telesis AR400 Series: How To Configure (6 pages), Troubleshooting Manual (8 pages), Troubleshooting (5 pages), Quick Install Manual (8 pages), Quick Install Manual (12 pages), How-To (8 pages)

Allied Telesis AR400 Series Safety Information Manual
AR400 SERIES ROUTER
Safety
WARNING: In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
ELECTRICAL NOTICES
WARNING: ELECTRIC SHOCK HAZARD
To prevent ELECTRIC shock , do not remove the cover. No user-serviceable parts inside.
This unit contains HAZARDOUS VOLTAGES and should only be opened by a trained
and qualified technician.
LIGHTNING DANGER
DANGER: DO NOT WORK on equipment or CABLES during periods of

LIGHTNING ACTIVITY.

CAUTION: POWER CORD IS USED AS A DISCONNECTION DEVICE. TO
DE-ENERGIZE EQUIPMENT, disconnect the power cord.
ELECTRICAL - TYPE CLASS 1 EQUIPMENT
THIS EQUIPMENT MUST BE EARTHED. Power plug must be connected to a properly
wired earth ground socket outlet. An improperly wired socket outlet could place
hazardous voltages on accessible metal parts.
PLUGGABLE EQUIPMENT, the socket outlet shall be installed near the equipment and
shall be easily accessible.
CAUTION: Air vents must not be blocked and must have free access to the room
ambient air for cooling.
OPERATING TEMPERATURE: This product is designed for a maximum ambient
temperature of 40 degrees C.
ALL COUNTRIES: Install product in accordance with local and
National Electrical Codes.
WARNING: Only trained and qualified personnel are allowed to install or replace
this equipment.
WARNING: As a safety precaution, a 10 Amp circuit breaker should be installed at the
supply end of the cable to be used with this LAN equipment.
ALWAYS connect the wiring to the LAN equipment first before connecting the wiring
to the breaker. To avoid the danger of physical injury from electrical shock, do not work
with HOT feeds. Always be sure that the breaker is in the OFF position before
connecting the wiring to the breaker.
ELECTRICAL - AC MAINS CIRCUIT OVERLOADING
When installing product, consideration must be given to the accumulative nameplate
ratings when connecting the equipment to the AC supply wiring.
Lithium Battery - Should only be changed by trained and qualified technicians.
CAUTION: Danger of explosion if battery incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer. Dispose of used batteries
according to the manufacturer's instructions.
4