AVPro Edge AC-EX100-444-KIT Quick Start Manual - Page 3
Browse online or download pdf Quick Start Manual for Extender AVPro Edge AC-EX100-444-KIT. AVPro Edge AC-EX100-444-KIT 8 pages.
Print Page
1080P Test Pattern
Control Signals:
The 444 series extenders can pass control signals from one device to another via IR and RS232.
IR Control Signals
IR control signals can be sent 3 different ways:
1.
From the rack using a control system (Control4, Crestron, etc):
a)
Plug one end of a 3.5mm mono cable into the control system
b)
Plug the other end of the 3.5mm mono cable into the "IR IN" on the Tx
c)
Plug the IR emitter into the "IR OUT" of the Rx
d)
Place the IR emitter on or near the IR receiver of the display or device that you'd like to control
e)
Be sure that the IR MODE switch on the Tx is set to "I-PASS"
2.
From the rack using IR:
a)
Plug the IR eye/receiver into "IR IN" on the Tx
b)
Plug the IR emitter into the "IR OUT" on the Rx
c)
Place the IR emitter on or near the IR receiver of the display or the device that you'd like to control
d)
Be sure that the IR MODE switch on the Tx is set to "IR-EYE"
3.
From the display end using IR:
a)
Plug the IR eye/receiver into the "IR IN" of the Rx
b)
Plug the IR transmitter into the "IR OUT" of the Tx
c)
Place the IR emitter on or near the IR receiver of the device that you'd like to control
d)
Be sure that the IR MODE switch on the Tx is set to "IR-EYE"
*NOTE - Only use the IR receiver and emitter that come with the 444 Extender kit
4K Test Pattern