CPA AMBRA Manual - Page 7

Browse online or download pdf Manual for Water Pump CPA AMBRA. CPA AMBRA 8 pages. Circulation water pump

Print Page
CPA AMBRA Manual
MANTEINANCE MANUAL
− The vibrations of the machine. In case of anomaly, stop the machine immediately
− The state of deterioration of the components, periodically replacing those worn by normal use (eg
O-rings, gaskets, bearings)
− In models with pre-filter, regularly clean the basket from the impurities collected to avoid
pressure drops and motor overheating in case of obstruction of the suction mouth.
exit
enter
WINTERING
Risk of freezing: if the pump remains at a temperature of less than or equal to 0 ° C for a long
time, the pump body must be completely emptied through the special drain located below the
pump body in order to prevent breakage and damage to the hydraulic components (fig. G). Then
clean with clean water, dry, remove and store in a dry place. The aforementioned operations are
also recommended for long periods of inactivity in normal temperature conditions. After a long
period of inactivity, repeat all the operations described for the first start-up.
PROBLEMS AND SOLUTIONS
Problem
The engine does not start
The engine runs without
pumping water
www.cpa-piscine.it
fig. F
Cause
Active thermal protection
Damaged thermal protection
Wrong wiring
Engine failure
Impeller blocked
Insufficient voltage
The water level in the suction
basin is too low or lower than the
suction point
Filter or shut-off valve
obstructed
Air bubbles in the suction pipe
clock
wise
base
Solution
If the engine is overheated, it will remain
inactive. It waits for it to cool for about
20-30 minutes
Replacement with a new one
Check the connection making sure it is
Conjtact a service center
Wash the impeller
Check the voltage present on the line
(qualified technical personnel)
Check the water level in the basin
Wash the elements
Check the tightness of the pipe
Check that the level of the intake
valve is less than 50 cm compared
to the free surface of the water
AMBRA
fig. G
secure.
Repeat the connection
joints.
Ver01– 2021-06-18
pag. 7 di 8