CPE 201055 Operator's Manual - Page 6

Browse online or download pdf Operator's Manual for Tools CPE 201055. CPE 201055 9 pages. Detachable hose reel

Print Page

201055 - DETAchAbLE hOSE REEL

ASSEMbLY



Carefully remove all parts from the packing box. Locate all

hardware and components before installation.



Do not completely tighten bolts until assembly is completed.

For easier assembly, we recommend that two people assemble

this product.



Ensure there are no live electric wires or plumbing in the wall

where you mount the hose reel.



Always use eye-protection when using power tools.

1. Position the mounting rail on the wall at a convenient height.

2. Use a bubble level to ensure the mounting rail is horizontal.

3. Mark hole centre locations on the wall.

4. Using a 14 mm (35/64 in.) masonry drill bit, drill

approximately 3.8 cm (1.5 in.) deep centered on the marks

you made in step 3.

NOTIcE

WARNING

3.8cm

5. Using a hammer, lightly tap the masonry anchors into the

holes, being careful not to damage them, until fully seated.

Remove the nuts and washers.

6. Hang the mounting rail onto the exposed anchors.

7. Replace the nuts and washers, tightening them with

a wrench.

1. Locate the studs using a stud finder.

2. Position the mounting rail on the wall at a convenient height.

3. Use a bubble level to ensure the mounting rail is horizontal.

4. Mark hole centre locations on the wall.

ASSEMbLY